it work fine on my 02 shogun, but make sure the ignition key is in ON position before doing it,otherwise it won't work.
Man
October 2016
Tried all , when I hold down both button the red light do,s not stay on . 2006 shogun sport 2.5 any help would be good
Cj
June 2015
Brill - just done this & works spot on!! Many thanks
v4vpw
November 2014
Tried all this on my 51 shogun 3.2 LWB and no good ...Remote is obviously not registering...Please help...
Nigel
April 2014
Works on my 01 plate shogun with a slight variation, ignition on, press and hold both buttons until light stops flashing, press big button once, ignition off and it works perfectly.
Mike C
March 2014
Any idea why when I hold big button down it is just a solid red light please?
2004 shogun
eadget
December 2013
Mitsubishi dealer wanted £108 to sort this for me just because I changed the battery. This info sorted it in seconds
Thanks everybody ;)
Tim C
July 2013
Just worked for me too on a 51 3.5 shogun elegance. Thanks very much!!
sweetmac
May 2013
Tried both ways with my zapper and when I press both the buttons the red light doesn't flash it is instantly solid? Any ideas?
Blackbeauty
February 2013
Spot on. 2004 Shogun Warrior 3.2 DID
Outside O/S Door
Held both buttons on remote until Red Light constant
Fingers off
Held Big button for 5 secs
Works a treat
Thanks!
Deadly
February 2013
Lovely worked for me aswell
Dan
December 2012
Outside the car, near the drivers door hold both buttons together for ten seconds until the LED light stays on, then hold the bigger button for one second and that should be it
Bertie Meeks
November 2012
it worked for me too 2004 shogun,thank you so much for sharing this information,saved me time on money going to main dealers
blip
October 2012
Just done the same. Turned on ignition, pressed both buttons for about 8 seconds untill red flashing light stayed on then removed key, waited 6 seconds and tried. Ideal all working.
cooperman
February 2012
IT WORKS _ FANTASTIC! Couldn't find answere on Mitshibushi web site!
Dexter
September 2011
hi, thanks for this it worked on my shogun 3.2 03 plate lwb, saved me a packet i am sure.
big g
June 2011
Did the same - held both buttons till stayed red turned off ignition and bobs your uncle working spot on !!!!!!!!
Steve
April 2011
Just done the same on my 56 plate Shogun.
Put key in ingnition
Turn on and I pressed both buttons until red flashing lights stays on permenantly.
Turn of ignition and leave for 6 seconds.
Then remove and try!! Worked for me
howtomendit.com for free repair help, information and advice.
