Can you please help, my knitting machine works without the sinker plate on and when i put the plate on the needles do not move they dont do anything ,please help me , thank you
hello can you help? i have a problm with the machine needle going all the way through so it can catch the thread,the needle just dosnt go through can you recomend a local and reasonable machanic. thank you
mrs bibi
February 2010
IT COULD BE THAT YOUR SINKER PLATE HAS BEEN DROPPED AND SLIGHTLY OFF LINE...HAVE A CAREFUL LOOK ALONG THE LINE AND MAKE SURE IT IS NOT BENT A LITTLE
HOPE THIS HELPS.
ANGELINA
February 2010
Hi,
It sounds as if your carriage is not properly seated on the needlebed. Remove the sinker plate then remove the carriage.
Replace it, making sure that it is resting evenly on the needlebed and that the front is not raised. Then put the sinker plate on making sure that it seats properly on the positioning lugs.
I hope this helps,
Sue
February 2010
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
