fault codes for indesit iwdc 6125 uk?

All The top lights are flashing, unable to open door and water still in the machine, i have tried unplugging but the problem still persists, many thanks

Michael
January 2023

i have ainstruction book

john singh
April 2016

Same problem here too it fills up with water starts the normal process but it does not drain anymore lights start flashing and its just out of warranty. I have just tried doing the usual cleaning the filter checking the motherboard but cant see an issue. Indesit will not come out unless I give them £85 which is half the cost of the machine. What a useless company

Rory
July 2014

I have an Indesit washer dryer IWDS6125 and it had stopped working and had water in the bottom. I drained the filter so theres no water remaining in the drum however, no matter what cycle i set it on, it goes for about 5 mins then stops and all the lights are flashing. Any advice would be appreciated :)

Jemma
April 2013

i have an indiset iwdc 6125 washer drier. The drum will not empty & the drum has stopped turning.
Could anybody point me in the write direction.

Many thanks in advance

AKB ALLY
October 2012

my machine has no eletrical power but rest of appliances do. i have checked fuse.

Jenny
June 2012

I use one of these at work and have the same problem. could it be that we are exceeding the 5kg drying capacity?? it used to do this every now and again but now its all the time. not sure it is a weight problem as i wash pieces of fabric cut to the same size each time. tho maybe it depends how effective the spin was at removing the water??

Dee
August 2011

Try unplugging for a few minutes then turn it on..if it still doesnt work...Turn The Washing Mashine Off,unplug it,Take The Bottom Peice (cover panel) Off the washing machine at the front of it with a Knife/screwdriver,Unscrew the lid anti clockwise (But if the washing mashine is full of water you will after keep filling things up with water till its empty,put a towel down aswell as abit of water will trickle out anyway (this is normal) clean the inside out throughly and check there is nothing in there that shouldnt be. then screw it back on and put the front cover back on (making sure the hooks are sucurely in place before you push it onto the washing mashine.

X-MT-X
December 2010

hello,

i would like to find the manuel for the washing machine iwdc 6125.
i dont undersand how to use it.

please send me the guide .
thanks

hytachyba
June 2010

My machine has the same problem. I don't know what the problem is, but I know what it isn't. I had an engineer out and he thought the control thermistors were faulty - he showed them to me and it did look like their casings were not sealed. He replaced them. But the problem still occurs after that.

Jay
May 2010