i have a 58 plate v clic its done less than 2000 miles it was abit stuttery in the morning and took about 10 mins before i could rev it up full then one mornining it started first time like always then cut out and would not start i bought a new plug and thought this would fix it think again no difference i cleaned the carb out no difference does not seem to be getting a spark any ideas thanks
see...
http://www.pedparts.co.uk/blog/peugeot-v-clic-cdi-no-spark-pinouts
for v-clic no-spark fault finding!
James
September 2014
Hi we have just put a new engine in my son's v clic but now it will not start the petrol is not getting threw
clare
May 2014
It will start after about ten minites and will tick over but when you go to rev it nothing happens i have checket the throtle and it seems fine just wont rev
jacccchhhh
August 2013
Hi sounds like auto choke unit or choke capacitor unit are shot we had same trouble also check your valve clearence
adejg
June 2013
My sons ped had same issue. check connection on ht coil. it is located rear right side attached to frame and visible without removing any plastic. it is exposed to weather and road crap. clean connectors and pinch with plyers to make tight fit.
pete goodwin
June 2012
i bought a v clic 50cc but it wont start, does anybody know how the starter switch on the stand should be positioned as it was taped up and now the tape has come off !
fatboy
January 2012
The spark plug is located under the storge compartment. tou have to remove the whole compartment and it is underneath on the side
deborah
June 2011
i know this isnt an answer but I have been looking EVERYWHERE to try to find out how to get access to where the spark plug is on the v-clic. I have recently bought an 08 model which has done 1500 miles. new battery and serviced in oct last year. It has not been used during this spell of cold weather and the only think i can think that is the problem is the spark plug but just cant get to it! please help!
Tom Stamp
February 2011
Thanks for your help i bought a new cdi i bought a new ht lead i bought new relay i bought a new rotor the only thing ive not changed is the regulator as i cant find it and still i have no spark close to making my own spark and setting it alight help please
marc
February 2010
Thanks i will try this
mm05kat
January 2010
try disconnecting the ignition switch and kickstarting it and see if it goes then if it does then the ignition switch is faulty .also it could be the side stand switch plying up have a look at it and see if its moving in and out ok when you put the stand up and down .obviously there are alot of problems that can cause a loss of spark the cdi may have packed up and its not uncommon on these peugeot v clics as they are a chinese budget bike made under license from peugeot its the same a baotian 50qt and a starway 50qt.also the stator coil may have packed up that generates the primary source of power for the ignition system.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix motorcycles.