valve adjustment on cr250f?

My 2006 CRF250 had the same problem! It was because the valves got to tight. You are going to need to adjust the valves because is most likly the problem. Once you adjust the valves back to specs the compression is a lot better.

derrek
April 2006

i work for a bike shop but i wouldnt say they are all ok and some rip u off and give out bad info and do bad jobs so i know what you mean,anyway look at the answer i gave to the question above you on the list hope it helps,it could be the de compressor but its unlikely try moving it with your fingers to see if its stuck in one postition if it is then it could well be that if u can move it though it will always go back to its resting position which doesnt interfere with the valves unless you use it,if its joined to the kickstart via a cable then try disconnecting the cable to see if that helps u its not that hard to start a xr 250 without using the decomp anyway try a 650cc one if you want hard lol they are a bitch ok good luck ,adam

adam
March 2006