Recent: Safely remove screen protector from a Macbook Air?

Mend > Washing Machines

Mend Hotpoint WT960 Machine Water Takes

hotpoint wt960 overfilling?

my machine is taking in too much water and only takes in the water from the softener side of the drawer, therefore not taking in the powder. it wont drain properly and still fills with water when i cancel the cycle. also it still continues to intake water even when i switch off the machine from the control panel. is it repairable or is a new machine required? thanks

charlene
September 2009
It worked..Ha.Ha.Ha..I just saved myself a hatful of money....Thank you so much!!

Andy
April 2011
take the rear panel off at the bottom ( 2/4 screws ) on the rear of the machine you should see a hose in the centre feeding the pump, loosen the j - clip and remove ( remember the machine will be full of water ) there is a filter inside and a float ball, clean out and rebuild, job done
please note if when taking the back panel off, check the module on the left handside & if it has a big heat sink, let the machine discharge for 5 minutes b4 working on.

foot
September 2009

Automatic Answer

We may have found other answers which could help you.

Click here for Machine Water Takes

Related Questions ...

Mend servis water problem spin
1

Servis M6856W takes on water but does not wash?

I have a problem with a Servis M6856W it takes on water but does not wash, spin or take the softner into the m... [Read more]
Mend washing machine drain spinning
1

Takes in water but displayed end and drain immediately ?

i have sharp front load washing machine model ES-V70FX-W , the machine switched on and Takes in water but disp... [Read more]
Mend washing machine error code drainage
1

My defy Automaid 600, DAW317 does not spin?

The machine takes water and washes, drains the water as per selected program but does not spindry. It does not... [Read more]
Mend change machine water
2

How do I change the brushes?

Candy washing machine wont go on to wash after it takes the water in
Mend washing machine fabric softener
1

my Beko wm61675 washing machine doesn't take the fabric softener? ?

My washing machine no longer takes the comfort(fabric softener) from the middle section of the draw, it fills ... [Read more]
Mend washing machine repair drain
1

how can I fix tricity bendix model AW1050 WM?

Tricity bendix washing machine model Aw1050 only takes in and drains water but no wash or spin what can I do.
Mend washer/dryer drain error
1

How can I fix a Zanussi Washer/Dryer Model: WJD1270W?

When I set the machine to wash (any cycle), it fills with water, the water jet starts, the machine takes the s... [Read more]
Mend fisher paykel washing
1

How can I fix my Fisher and Paykel FabricSmart washing machine - Error 112?

Hi, My washing machine takes in a little bit of water and then stops. After this the machine keeps on beepi... [Read more]
Mend washing machine appliances repair
1

why does the water not heat up in my servis washing machine?

The water in my servis washing machine does not heat and also sometimes takes hours to finish its cycle.Anyone... [Read more]
Mend washing machine bosch repair
1

How to fix washing machine Logixx 1600/1400 Express. ?

Bosch Logixx 1600/1400 Express washing machine fills with water takes detergent clicks as if going to start wa... [Read more]
Mend washing machine drum appliance
1

What is the purpose of the smaller rubber pipe from draw to drum?

My washing machine has 2 black rubber pipes connecting the drum outer casing with the soap dispenser draw. T... [Read more]
Mend washing machine flashing light pump
2

Haus WM1050W stopped?

Put a second load of washing on, went back in kitchen 10 mins later and machine stopped with flashing light. I... [Read more]
Mend washing machine repair drain
1

How can i fix my drum on my aquarius wd61?

the drum on my machine is not going round it takes in water as usual and drains it ok but there is no movement... [Read more]
Mend washing machine error electrolux
3

Washing machine-Electrolux Zanussi Jetsystem?

Cycle starts. takes in water, then cycles paused, wont start again ; first displayed E40 error message then E1... [Read more]
Mend simpson cycle going
3

simpson eziset 750 water flow?

wash cycle takes to long water was going into the machine very slow had a look at the hose conection and found... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Washing Machines ...