Error message Sam4s ER-5115?

e 1

dilip
October 2016

pp_0.00

Pankaj
September 2016

I am trying to add items to create an inventory.

1.turn the key to P
2. press 250 subtl
3.scan item - it comes up
4.press how many i.e. 20
5.press x/time

message "warning stock error" appears every time....please help.

The Caribbean Spot
May 2016

I have an e1 error and a buzz sound. How do I clear this?

mary
November 2013

i have a sams4. warning EJ memory full appears . how can i reset the machine?

kirit patel
May 2013

is no working and closed message apear

platanito loco
December 2010

pull the plug, remove both paper rolls and ribbon, plug in. if printer doesn't cycle, printhead carriage is jammed. If it only jams up with the ribbon installed, the feed pawl on the right side of the ribbon plate is bent and jamming under the cartridge. This pawl breaks easily when bent, so ribbon plate should be replaced.

mcfxr
April 2010

PP error is a printer error. normally, check to make sure there is no paper jammed between the printhead and the print platform. also check to see if there are any paper shards caught in any sensors inside of the printer and that the ribbon is not jammed. if the printer looks clear, try to do a staus clear: turn P key to P position on keylock, unplug register power, hold SUBTOTAL while plugging in power. If printer cycles and shows CLOSED, you should be good to go...

mike
November 2009

Does the printer cycle when plugged back in to outlet? If not look for paper jammed in printer. Remove all paper & see if paper path is clear. May have to tale screws off top of printer and cycle gears by hand.

defaxman
October 2009

No dealer in my area

Pam
October 2009

I am also trying to find the error answer

Pam
October 2009

In that case it could be printer failure. Best to take it to a dealer

Mark
September 2009