thanks zanussi washer dryer?

CK you had earlier advised me to check a set of things my question under the heading zanussi washer/ dryer wjs1265w so i had posted a reply can you check that pls also when you say tech sensor is there a seperate sensor along with the techo device fault before this was :

zanussi wjs1265 washer dryer?
condensor plumbing top end came off due to vibrations(a small screw which holds top part of condenser plumbing from back of the machine with a rubber washer was found on the floor) and top part of the machine was wet with foam also some on the fan motor elements as they were found partly rusted but it still works fine problem is that machine will try to spin but in 2seconds stops and keeps on doing that without further progressing into a full spin.I tried it by the way after leaving it to dry for a week.and now its been over 2months but its still the same.all pressure hoses and vessel have been checked no moisture went in the pcb it was all dry i dont know where thr balance switch is situated if theres any in zanussi wjs1265w washer/dryer before the leak the machine was working fine as many a responses will be nice thanks to all thanks

patrick
July 2009

there is no adjustment that you should do as they are preset at manufacture.you may of broken it!.there is no balance switch it is controlled by the main control pcb and a tacho sensor on the motor.what was the fault prior to you technical adjustment?.

ck
June 2009