How can I fix my Horizon Omega treadmill ?

Anyone have any idea how to fix horizon 3.0 run
Away problem? I am old 62 and I di a pretty good clio but this burst of speed scares me as I don't bounce as well as I once did.

martha old but still kicking and most importantly breathing.
June 2016

I have a horizon treadmill reads lube I used silicone lub on inside of walk and still does not work
thanks

mary ann
December 2015

hi
i have an omega 111 treadmill but when i start it up it run for
5/10 seconds and then the motor stops,
display is fine, any suggestions'

wayne thomas
April 2015

Hello I have a Horizon Omega 3 HRC, its stopped working and shows 500 on the display panel. Just wondering if anyone can help me to find out what the fault means?

Claire x
October 2013

Hi.
Before you start buying expensive semiconductors check r9 and r13 resistors (capacitor decouplers).
They are rated at 100kr at 5w.
They will probably be high or indeed o\c.

Regards.
Paul dawson.

Paul Dawson
August 2013

Anyone got the service manual? the link isn't working.

Mark
October 2007

E-1 Error-message on the Upper Board
If there is belt movement upon start up of the treadmill, and an E-1
message occurs, follow the possible causes below:
Possible cause:
.
• Check all wire connections.
• Verify that the sensor magnet is positioned in the front roller pulley.
• Verify the distance between the RPM sensor wire and the front roller pulley
(2-4 mm). Reposition the RPM sensor closer to the pulley if possible.
• Adjust the speed dial on the lower board to increase the treadmill speed
slightly (reference speed calibration in table of contents).
• Verify the signal of the RPM sensor by entering Diagnostics Mode. If there is
no signal present, check the continuity of the RPM sensor wire. If there is no
continuity, replace the sensor wire.
• If the problem persists, replace the upper board.
If there is no belt movement upon start up of the treadmill, and an E-1
message occurs, follow the possible causes below:
Possible cause:
• Verify that all wire connections are properly attached.
• Adjust the speed dial on the lower board to increase the treadmill speed slightly.
• Verify the diagnostic LED’s on the lower board. Reference diagnostic LED chart
for possible causes.
• If problem persists, replace the lower board.


source: service manual : http://www.horizonfitness.com/sb/service-guides/02-03Treadservicemanual.pdf

Bryan
August 2007

hi just fixed my treadmill fired up for 5 seconds or so came up error i bared the wires that feed the speed sensor if it is magnetic and set the mill to low speed and flicked the wires together to coincide with the magnet passing the sensor and it worked then experimented with a bike sensor one of those cheep bike speedo works a treat good luck picked up the treadmill from local tip 3 pounds fantastic condition

nick
August 2007

Sorry, not an answer but my machine has just done exactly the same thing. The motor turns very slowly for about 5 seconds, irrespcective of speed setting and then stops with the E1 error. The belt seems to move freely so I cannot think it is this. I'll be watching for any answers as well. Andrew

Andrew
January 2006