Recent: Home max fs506x?

Mend > Home Heating Systems

Mend Worcester Boiler Pressure Radiators

worcester 28i boiler - increase pressure ?

After bleeding the radiators, the gauge now shows at almost zero (with the radiators off). How can I increase this to the manufacturers recommended 1.5 - 2
There is a silver hose which links the domestic input and central heating return pipes. (picture included)
Thanks
Any help would be greatly appreciated.
Here are the pics in the following links -
[URL=http://imageshack.us][IMG]http://img56.imageshack.us/img56/9578/dscf3553de0.jpg[/IMG][/URL]
[URL=http://imageshack.us][IMG]http://img49.imageshack.us/img49/3936/dscf3554wt9.jpg[/IMG][/URL]
[URL=http://imageshack.us][IMG]http://img49.imageshack.us/img49/1760/dscf3555ov5.jpg[/IMG][/URL]

Fifi and the kids
December 2008
if you can hear water running leave a bit longer
the pressure should go up

b
December 2008
thanks for getting back
there is not a tap on either end of the pipe. There was a blue plastic lever? over a screw on the domestic input end, which came crumbled in my hand.
I opened that screw and the one at the other end. Water came out of the "central heating return" end, but the gauge did not increase, after about 1 minute.
Should I have left it longer ? Is it right there was water?

Fifi and the kids
December 2008
at each end of the hose should be a tap.
open one then open the other untill the presure gets
to 1 bar

b
December 2008

Related Questions ...

Mend boiler pressure radiators
1

over pressure?

I have a greenstar 24i boiler, pressure is normal, when I turn heating on pressure increases and eventually op... [Read more]
Mend heating boiler radiator
1

Problem with the pressure in combi boiler?

My valent combi boiler has problem with the pressure which keeps on falling which causes the radiator not to h... [Read more]
Mend boiler radiators pressure
2

I only have heating downstairs... ?

Hi all. My heating has been a bit funny. The radiators upstairs aren't heating up at all and the ones downstai... [Read more]
Mend boiler heating pressure
1

how to reduce boiler pressure ?

i have set the bar pressure on my greenstar 37 cdi to high. how do I reduce it to proper level. Do I use the k... [Read more]
Mend pressure worcester heat
1

Faulty Worscester 35 CDi loosing pressure?

My Worcester 35cdi has had 4 replacement heat exchanger's in less than 10 years the first 2 were within the fi... [Read more]
Mend boiler heating radiators
1

How do I raise the pressure on my boiler after bleeding radiators?

How do I raise the pressure on my worcester heatslave 20- 25 oil boiler after I have bled the radiators
Mend boiler heating thermostat
1

combi oil Worcester greenstar heatslave 12/18 switches off?

I have a internal combi oil Worcester greenstar heatslave 12/18 Its has a built programmer and Hot water t... [Read more]
Mend heating pressure radiators
1

how can i lower the pressure in boiler ECLIPSE 216 ESS please ???? ?

my radiators are old and have the draining valve at the back of each of them so access is ni on impossible;[ ... [Read more]
Mend combi boiler pressure pilot
1

Worcester combi boiler has lost pressure after bleeding radiators?

I bled radiators now digital pilot light off and pressure gauge on zero. Help please!
Mend combi boiler pressure pump fault
1

Baxi combi will not restart after changing radiator?

I have a Baxi combi 105E boiler and have fitted a new towel radiator.after refilling system (all radiators ha... [Read more]
Mend heating radiators boiler
2

How do I stop water from flowing outside from my ferroli optima 901 boiler?

Pressure bar is constantly at 3. If I drain radiators, pressure reduces but then creeps back up again. I have ... [Read more]
Mend boiler heating pressure
2

how to pressure boiler after bleeding radiators?

we have bleed the radiators and the pressure has dropped how can we re-pressurise
Mend boiler 28 pressure
1

Remeha avanta boiler 28 - help???

Hi I have just had my boiler serviced in November and since , it keeps losing pressure down to 0 everyday, tod... [Read more]
Mend low pressure heating system
1

low pressure on heating system?

my boiler will not allow me to pressurise the radiators to the correct pressure even though the mains pressur... [Read more]
Mend boiler heating fault code
1

How can I get my water and heating to work?

I have a ideal logic combi 24 boiler with a fault showing code f1, I know this is the pressure, I've turned va... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Home Heating Systems ...