i flick the heating on flame raws as it should do but the fan to blow it around the house doesnt spin , i,ve tap it wiggled some wires checked the only fuse i can see , its fine , any one any idears!
cheers tony your a star i,ll have a closer look tomorrow, thanks again
martin
December 2008
The fans are easy peasy to change.Just one nut and bolt and unclip the wire from the junction box.I used to use Gas Appliance Spares at Preston but not Regd now so not sure on price though would expect it to be fairly expensive.If there is any chance of putting a multi meter across the fan when you hear the click just to confirm that there is power at the fan before you spend your dosh.Plumb center also have a parts center but shop around as you will be surprised at the different quotes you will get.
Tony S
December 2008
thanks tony had a look and it clicks like you say , the fan doesnt even try and turn , do you think i can get a new fan and are they easy to fit , it does,nt look that hard!!! any idear of a price regards martin 07747 690 192
martin
December 2008
After the mainflame has lit can you hear a click after about a minute.If you can this will be the microswitch which feeds power to the fan.These were quite bad for the fan seizing up.Pull the filter out and take off the front panel,2 phillips screws.You will then see the fan in front of you.Turn on the main burner paying attention to the fan when you hear the click.If you see it jerk then its probably the fan motor thats packed in.
howtomendit.com for free repair help, information and advice.
