Fisher & Paykel Washer (IW812) Error Codes 136?

it was the motor, is there a parts site i can purchase new motor
Thanks
Lincoln Appliance NZ

Jim
December 2008

Error code 136 - motor stall. Means control module has detected that motor is not moving. Check wiring harness for damaged wires. Check motor windings. These can be checked from inside the panel. There will be a harness plug with 5 wires plugged in to module. White & brown wires are for pump. Use a multimeter on ohms range & check between red-blue, blue-yellow & yellow -red. Should be approx. 32ohms between each. Next try rotating bowl by hand to see if bearings are seizing up. If all ok then there may be a problem with the control module circuit board.

Lincoln Appliance NZ
December 2008