Door spring broken (?) on Fisher and Paykel dishwasher Model 920?

For Model 920 and 918TD dishwashers the fix is the same:
1. There are two panels, in the front of the dishwasher, that lie below the door. The uppermost panel needs to be removed before the flat fascia under it. With these two off you can replace the springs.
2. Remove the upper panel by looking for recessed holes underneath it at either end. Poking a philips #1 screwdriver up into the recesses will allow you to unscrew them. The screws are captive and will not fall out. Ignore the bolt centrally located under the door. Its for an earth wire and we won't need to touch it.
3. The upper panel will now fall off. Lie it down on the floor in front. Its a convenient receptacle for screws and springs.
4. Remove the lower panel by first pulling off the earth tab. Then slide the panel up an inch or two until it comes forward and pulls away. There are two locking clips underneath. These clip onto the underside of the washer. Friction only, no screws. They will release by pulling the panel towards you. Slide it up first then pull it towards you. Set this panel to one side.
5. You can now see the springs from the front. They may appear hard to get out and replace but it is simple.
6. There is a small screw in front of each spring which holds the side panel onto the base. Unscrew these and put them in the tray for safekeeping.
7. Stretch the spring down and pull it towards the loosened side panel. The bottom of the spring will then detach.
8. Twist and push the spring up to release it at the top. Do this for both of them. Throw them away.
9 Install new springs. The springs both have to be put in with the hook part facing inwards (so the bottom can be clipped on).
10. Attach the top of the spring first by pushing and twisting it in. Make sure its properly in before stretching the spring slightly down and clipping it over the base. Because the side panels are loose this is easy to do . Impossible otherwise.
11. Reassembly. put the flat fascia back on by pushing it in high and letting it slide down. Then push the bottom of the fascia until it clips in.
12. Push the earth lug back on.
13. Screw the upper panel back on using the recessed screws. Done.

MarkS
January 2013

Remove panel under the door, there is 2 Phillips #1 screws underneath this panel in the rectangle slots.
Remove the kick panel - slide it up until the plastic plugs come out of the slots.
Unplug the earth terminal tag.
The springs are now visible on the left & right through the holes. Un-hook the broken spring - repair or replace it.
Reassemble it reverse order & remember to plug in the earth terminal tag!

michael.c
July 2009

fisher parts in the uk can be ordered from sales@gwhitedist.co.uk

joe m
November 2005