Ford Transit Van 2002?

you need to go through the back of the hub witha screwdriver and wind the brakes off, this is done by turning a small wheel,to check that your going the right direction periodically turn the wheel, absolute pig of a job, you will need a torch, approximately six inch flat bladed screwdriver and a whole lot of patience, good luck,

Chris O
December 2007

to remove the hub all you have to do is knock a stud through the drum allowing u to get to he cable adjuster using a flat blade screwdriver u can slacken the cable allow the drum to come off

mike
September 2006

i have recently done mine u have to ensure hand brake is off.
begin by tapping around the drum to free the rust. then u will need a hub puller/slide hammer. they are very tight? it took a good half hour of hammering to remove it.

dave (hull)
November 2005