Check out the carbon brushes in the motor. Theyre graphite blocks which transfer mains power to the copper segments of the motor -Theyre probably worn down. They're quite cheap parts and easy to replace. Power off, remove the back cover and locate the motor. May help if the machine is tilted at an angle or laid on its side. The brushes are at the other end of the motor from the drive pulley. The holders are plastic or bakelite and are generally held in with screws or plastic clips. Also, look at the copper segments they run on to check for burning or pitting.
Other possible causes of spin problems: Faulty pressure switch - machine "thinks" the drum is still full of water so wont enter the spin cycle. An easy way to check is to remove the hose connected to the pressure switch and listen for a click, this will happen the instant the hose is removed so be aware. if you do hear a click it means the switch has reset, so the pressure chamber attached to the other end of the pipe is blocked, which will require you to remove it and clean it out. If there is no click either you missed it or the switch contacts are welded together. To test the switch you may have to remove it because you will need to blow into it and listen for one or more clicks as the different levels set. Be aware that some of the older machines have multi level switches, whilst the newer ones only have a single level. Spin problems may also be caused if the machine reckons the load is out of balance, rearrange the load. If problem persists could possibly be a fault in the out of balance detector switch or the suspension and damping system.
Repair and service your own washing machine. Go to www.2ndwave.co.uk/manual.html
dannyboy
November 2008
howtomendit.com for free repair help, information and advice.
