back end low?

hi my megane is low at the driver side i have changed the shocks but still the same what can it be its a renault megane 1.4 petrol on a y plate

matt
February 2009

hi K i dont suppose you have msn do you so that we could have a chat about it sorry if im a pain. cheers

Roger
November 2008

yes there are 2 per side but only the 2 to outer arms are usually disturbed. when i have changed bushes i did one side at a time then could use other undisturbed arm as a setting!. will probably be a case of trial and error-there is no master spline,

k
November 2008

is there a certain way to re position the torsion bar i think there is 2 but could be mistaken.

Roger
November 2008

if not snapped it will be torsion bars that have been removed to replace rear suspension bushes and put back in wrong position! you could try jacking up van till little or no weight on rear susp [you will need shocks off or disconnected] in end of torsion bar is i think a 10mm or 12mm thread to which you could attach a slide hammer to pull out bar then you could re-position it. they are very tight you may end up taking axle out to cure your problem! awful job [speaking from experience takes, a good day to replace bushes].

k
November 2008