HOW TO RESET PROGRAMS ON H.POINT WF445 AFTER REPLACING BEARINGS & SEAL?

indication of a fault condition in the machine. If the machine was on its side or back during the work, the pressure vessel may have been blocked with debris.
Check the pressure switch -the system that determines correct water level in the drum. Its a round item about 3 inches across with several wires connected, it sits under the top cover. Its an air operated switch which tells the machine water has reached the correct level. Disconnect the thin rubber pipe from the switch and blow down through it to clear any blockage. Switch itself may be faulty but its more likely the pressure pipe or the vessel attached to the other end of the pipe is blocked.

Repair and service your own washing machine. Go to www.2ndwave.co.uk/manual.html

dannyboy
November 2008