Mend > Dishwashers

Mend Smeg DWF614SS Dishwasher Error Repair

Smeg E1 error - how to I reset?

My Smeg DWF614SS dishwasher keeps stopping mid cycle displaying the E1 error code which I understand means the anti flooding system has been tripped. Dishwasher seems relatively dry inside and have, as the manual suggested, switched off, opened door and started again - but after sometime E1 code appears again - any ideas before I call the repair man out - I have tried turning it off at the mains and re-starting but this also makes no difference.

Aneesa
November 2008

Smeg Smeg DWF614SS Kitchen Appliances, Dishwashers Dishwasher Error Repair

If the failure occurs after the main wash pump start (shortly after filling is complete) check that the lower spray arm is not split - a split spray arm will spray water directly at the lower door seal and cause the water to overwhelm the seal and end up in the base, triggering an error 1.

Got the T-Shirt
December 2022

My smeg dishwasher keeps flashing up E1 what does this mean?? Please help.

Belinda
February 2016

Having problems with my smeg dishwasher error code 1 keeps coning up

michael
September 2014

Take the right side panel off & check the O rings are sealing on the water inlet. I've had this problem for weeks & have done this & found the O ring have moved & leak water into the tray when filling & trips the anti flood device.

RCF396
January 2014

I left my dishwasher empty,open and switched off for a few (2-3 days) and then it just started working again as normal. I think I may be accidentilly tipping water in the gap by the hinge when loading the dishwasher and by leaving it open for a while, it drys out.

Housekeeper
November 2010

Hi Aneesa, it will mean that the base where the motor is has got water in it.I would call the engineer as if water gets on the motor it will short it and the costs will be much higher.All the best.,

FOXY
November 2008