Recent: Safely remove screen protector from a Macbook Air?

Mend > Home Heating Systems

Mend Ideal icos HE18 Boiler Heating Burner

Ideal icos HE18 boiler that never goes to Standby?

My HE18 seems to only have two modes -

'c' with a flashing burner light
or
'c' with a fully illuminated burner light

I am sure that it should go to standby mode when not in use.

Paul
September 2008
Any solutions to this? I have the same he18 boiler, same scenario. Boiler never goes into standby.
Nick Martin

Nick Martin
April 2010
I have nearly the same problem. My boiler does go into standby but the pump is on 24/7 even with the boiler off.
It is a new boiler with enough wires to do everything and is wired to an idiot proof Honeywell wiring centre.
Any ideas

Steve 1952
August 2009
Hi all,

Sorry I have been all over the shop and did not check here for your comments.

It has never done this from new, but I have had a plumber look at it and he is concerned that the boiler is not getting the right information back to put itself in to stanby.

As a result he thinks the 'Boilermate' is constantly on and the pumps are driving water around the system. He put it down to one of two things:

1. There were not enough wires available on the existing cabling for it to be installed correctly and communicate as it needs to
or
2. with the boilermate Storage System

There is another issue with the installation
Interestingly enough he pointed out the pumps attached to the 'Boilermate' are on 24x7 which points to problem 1 and it would be expensive to fix (running new cabling between the 'Boilermate' (upstairs) and the boiler itself (downstairs).

I hope this helps answer some of your questions. Paul

Paul
November 2008
Paul, did you ever get an answer, because I've got exactly the same problem? Although I think mine may be slightly bigger as it's linked to a Megaflow mains pressure water heater that doesn't want to turn off either! Cheers.

Nik
November 2008
No idea, it only came to light when I read the manual in full and noticed that it never displayed the standby mode.

Paul
September 2008
Has the boiler ever gone in to Standby since new ?

John
September 2008

Related Questions ...

Mend boiler heating pressure
2

Potterton Perfoma 24. Hot water works fine No heating?

Hi, I have a Potteron Perfoma 24 boiler. The heating has stopped working Hot water is working fine. I've trie... [Read more]
Mend boiler heating fault
1

Home heating systems?

Further fault Glow-Worm F100 gas boiler. When the boiler starts up the burner flame comes through the pilot l... [Read more]
Mend boiler ignition fault
1

Home heating systems?

I have a Glowworm 100f gas boiler system It has a fault where the ignition stays on when the pilot light is l... [Read more]
Mend combi boiler burner vokera
6

Vokera Maxin 28e combi boiler, DHW runs hot and cold?

A few months ago DHW temperature started to fluctuate mildly between hot and warm. This problem got worse so a... [Read more]
Mend boiler heating pressure
1

no pilot light no burner or clicking?

Came home to no centrol heating had hot water until used it up.so no hot water either .pressure gone from syst... [Read more]
Mend boiler heating baxi
1

Baxi Solo 3 50 PF Boiler - Only works when the hot water is set to 'on'?

Hi, I have a Baxi Solo 3 50 PF boiler. At the moment it is only working for hot water (which it doesn't se... [Read more]
Mend kingfisher potterton boiler
2

Kingfisher Potterton boiler?

Hi. We have a Kingfisher Potterton boiler which works efficiently and is regularly serviced with the last one ... [Read more]
Mend boiler heating hot water
1

No hot water on an ideal he30?

Hi I've got heating but hot water is not working properly Won't heat properly Boiler turns burner off very... [Read more]
Mend boiler heating ferroli
1

no heating or hot water, boiler will not fire up?

Ferolli 600 Pilot flame on Fan running Water pump running ... [Read more]
Mend boiler heating pressure
1

baxi 105e ch not heating the rads?

boiler seems to cycle properly no fault lights pressure gauge dropping boiler temp lights only going to 50 bef... [Read more]
Mend boiler heating hot water
2

how can i get my stat to on?

i have an rdj10rf,i followed the instructions,the reciever has both led and relay light on,so there seems to ... [Read more]
Mend boiler fault repair
1

how to fix boiler?

ideal isar he35 combi boiler... fault code h3 no heating or hot water.. burner light coming on
Mend Worcester Bosch Boiler Heating
1

Worcester Bosch 24/28 boiler?

Green 'indicator for burner operation' not showing. How can we get it back in. Hot water fine but can't put h... [Read more]
Mend boiler heating hot water
2

Vokera Boiler, Heating Working But No Hot Water?

We have a Vokera Maxin 28E boiler. The central heating works fine and the boiler lights every time. However re... [Read more]
Mend boiler heating radiators
1

why could my Swift Flow 75 boiler not work after changing my stop cock?

Swift Flow 75 - 80 Combi Boiler I changed my Stop Cock and now my Swift Flow 75 - 80 Boiler will not work. ... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Home Heating Systems ...