Hi, I have the same error message showing on mine, it bleeps and if I go to the machine and open the door there is a bit of water standing in the bottom, but if I change the display back to the programme it carries on quite happily to the end of the cycle.
What should I do to fix this? Is it a job for an engineer?
Any help would be much appreciated!
Nick
December 2008
Hi Dave, E6 is a not draining fault.It could be that the drain pump is blocked,that is at the front behind the inspection plate or possibly that there is water in the base from a leaking air break seal on the right hand side.Hope this helps, need further info just ask. All the best.
FOXY
September 2008
Automatic Answer
We may have found other answers which could help you.