how to mend tv aerial cable?

why do you need to do both? would have thought male to female would be enough. extra connections will just hurt the signal

steve
October 2009

A male and female f connector are also ideal and just screw onto cable with a little copper exposed and then screw together.

cb
September 2008

Hi Sue,
To do the job properly, you will need 2 male UHF plugs and one double female connector.
Essentially you are putting a male plug on each of the two cut ends and joining them by plugging them into the double female.
For an example of the male connection, take the UHF aerial out of the back of the tv and carefully unscrew the knurled ring. It is essential, for good reception, that the outer 'screen' cable does not touch the inner single core cable.

As a very temporary measure,switch the TV off and cut back each broken end. expose one inch of the outer cable and only half an inch of the inner.
Now twist join the two inners and cover the exposed copper with a few turns of insulation tape.
Now twist the two outers into a single strand and twist them together and insulate again.
Your tv will now work properly when you switch on

Cledlyn
August 2008