Ford Ka Heater fault ?

Where do I find blower resistor in a UK 2010 Ford Ka.......

Graeme Cook
April 2016

Just changed the resistor on my Ka, with the great guidance from above. Easy swap from the breaker's yard and for just £5!

Plumb1
January 2016

Help.
I have replaced the Heater control valve, it works now i think... I swich the car on, and it moves the sellonoid valve to the closed position, no hot water can pass through.
However, I also replaced the heater resister unit, the one near the passengers right foot, but it gets very very hot, to the point I think is beyond normal... I know it got hot because i tested the heater system before putting the resister unit back into its well, with the single screw and black plug with 4 wires. Still no hot air when I change the selector. Still a problem... need some advice please

Richard
May 2014

Replaced my KA solenoid heater valve 2004 yesterday easy access once you remove wipers and front panel it is right their from start to finish 1/2 hr dont bother stripping it down £25 not worth it sympathyse with folks driving around with the heater on dont go near a garage simple enough job Happy Repairs

leatherneck 10
April 2011

My heater is still blowing out air, but only cold air???? Being that it is minus degrees at the moment i could do with an answer to repair it!! Thanks.....

AJC
January 2010

Thanks for the advice. Got one off e-bay for £5. Easy job to do.

Gaz
October 2008

Merckenzie is absolutely right about this. I was quoted £75 by my local garage today to fix this fault and after finding his post I fixed it for £8.92!!. The blower motor resistor is DEAD easy to find and replace (1 screw and a push-fit connector with a safety clip). It will take about 5 minutes if you are a slow worker!!

Patrickzero
October 2008

Hi Re fan speeds not working, the resistor is a small box held in place with one pozidrive screw in the passenger footwell, just about where your right foot would be. There is a block connector with 4 wires coming from it. Literally a 2 minute job. The part less than a tenner from Ford dealer. Common problem, so they will probably have it in stock. I replaced mine tonight!

Merckenzie
August 2008

ka 1997 the heater blower does not work, i,ve changed the 4 speed switch it still does not work any body please help

india1
August 2008

Hi, the heater control is a variable resistor that makes up part of the electronics unit behind the panel they do fail but normally its the valve that fails first

nigel
April 2008