defy washing machine wont spin defy automaid?

My Defy washing machine came smoke at the back and stopped functioning, could it be the mote or wires burnt? It was a little slow on spinning and draining waster lately or spin but clothes will be still dripping water still

Vicky
February 2014

Hi I have just replaced my OLD Defy automaid after at least 16 years of loyal service..One of the reasons I replaced it was this same problem..I used to get around the problem by switching it off for 10 mins to cool down ,and then switch back on to continue spin...I did not investigate the thermister (that is in the spin circuit,because the spin uses a different winding on the motor) I finally got rid because there was a massive water leak which ,after dismantling turned out to be a massive rust hole on outer drum by the heater element..

Frank Dahl (australia)
September 2012

Replaced the timer with new one, but spinning cycle still not working. Model Daw265

Gideon
May 2012

Spot on! If you can start the motor turning manually, it is the capacitor (big cylindrical thing near the top of the defy) - rated at 16 micro farad or uF. Cost me R51.
Many thanks!!

Mike
March 2011

I have a Hotpoint Aquarius WM74 washing machine ,it washes fine just wont spin, I have cleaned all pipes at the pump and the one onto the drum,cleaned drainage pipe,checked water pipes,says, error code 15 check outlet pipes

Christine
March 2011

Defy washing machine washes but does not spin....problem solved by removing the pump and cleaning it out (Mine has 3 coins stuck in it). Once removed it washes and spins.....whooohooo, saved myself R800....

Louis
August 2010

Hi, I have two Defy automaid machines withthe same "wont spin " problem. Had the motors checked and replaced the caps but no go. I found that if you manually help the motoer to turn it will spin. This means the Timer switch is not providing connection from cap to motor. If i get a wiring diagram I can work out a fix using relays etc but can't find the diagram.. anyone help?

Donald
November 2009

The Timer switch and capacitor are the two most common parts in the Defy Automaid. Mine gave up after about 13 years, and you can have these two components replaced for about R700, other than that it's a great maching.

Kero
October 2009

Diana

I have had the same problem with our Defy Automaid and the crowd that so-called fixed it, said they replaced the capacitor (was not a new capacitor, if they did replace it). That cost nearly R 800 with a 2 month guarantee. However, after 3 months, same problem. I fiddled around with the machine and got it to work. The selector knob plays up, and by gently turning it, you can get the spin cycle to work again.

Neville Emslie
July 2009