How can I fix the charging system on my Murry ride-on. It has a12hp Briggs & Stratton vertical shaft engine. I get a reading of 9volts at the two wires comming from the engine - is this correct or should it be 12volts? How do I get at the charging unit to change it? Where can I buy a new charging unit?
Any help greatly appreciated.
How do i go about checking the charging system on a briggs engine,The battery will not stay charged,I know it could be the battery but it was replaced a few months back.Not to say it is not just bad....please help!
Randy
April 2010
691185 3 wire is too expensive. any one have the schmatic for the internal parts at 5 buck and not 70 bucks?
find the conector and wire color and check the voltage with the regulator disconnected.
mike
April 2008
Briggs engines use a flywheel generator that produces AC - this is rectified to DC using either a single diode or the modern types use a proper rectifier and voltage regulator pack - identified by noticing cooling fins on it. Electric starters use 12v DC. Quote the 3 banks of number code digits to a B&S agent and they'll tell you what you need.
John
March 2008
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
