freelander immobiliser?

Just had same problem. Parked Freelander (petrol 1999) on drive went back to it 10 mins later, central locking inop. no ignition and red immob. light on in dash. Read every thread/forum on the web looking for answers but they all sounded rather expensive. asked an 'old timer' and he said that on the old Rovers the trick was to undo the pos. terminal from battery and touch it back on a few time as this sometimes shocked the imob. back into life. I tried this and it worked. just need to remember to always carry a 13mm spanner with me!

colin gilbert
October 2014

Just bought a 1997 Freelander.Any one know how to use the fob alarm,it very confusing !! :((

Jordan
November 2012

just got my second hand freelander home and it dos,nt start. checked out the little red wire to the starter motor that mick above pointed out and it was loose. one little push and it clicks into place and the car starts! good job I never called out a garage. least I know now. cheers mick.

george
November 2010

Hi Did you find an answer to this fault as my 2000 diesel freelander has just done the same also the lock/unlock switch has stoped working along with the rear screen raise/lower switch at the same time

chris
July 2010

I read something about having too many keys on the key chain. They somehow interfere with the immobilizer system. (Affect the effect of the magnet on the piece that is in the steering column???) Anyway, I removed all of the keys from my keychain except the Freelander key and have not had a problem.

bpkirkwa
June 2009

me too i cleaned all termials even took the starter motor off and cleaned ,charged the battery,still no better,somone sugested that the alarm has to reactivated ,does anybody else know if this correct

Malc
April 2009

ive got the exact same problem and its doing my nut in aarrgghhh..someone save me before i take a sledgehammer to it.

first and last time freelander owner
January 2009

Dont know if this will help . but I had a similar problem on my 2000 Freelander . some times it would start and sometimes not, very frustrating . when it would,nt start exact symptoms as yours , everything on, turn key to start position nothing happens zilch . problem traced to red wire that goes to base of starter motor corroded so no feed to starter motor and no feedback to ignition . solution clean terminal of this offending wire and tighten up spade connection with pliers to give better connection . Go careful when cleaning this treminal cos if you are cleaning this with say a small wire brush and touch other terminals in vacinity causes a few sparks . Best use a bit of emery cloth .
Regards Mick .

Mick
September 2008

Same here... I've no idea how to sort this out! Can anyone please help?

Dave Cat
February 2008

Hey John

I have the same problem today!!! Did you find any answers?

Paul

Paul
February 2008