error code f-07 on indesit wie1575?

Indesit Wie147 read above forum ... my washing machine first kept sticking with 1min left on LCD and continued washing. Would have to switch it off, put on spin to finish clothes. Found out problem after going to work for the day and machine still going! After a week the error F-07 appeared
Took the following steps:
1. took plug out of wall
2. wiggled PCB
3. hit the back of the washing machine hard by the pcb (where mains lead runs into machine)
4. Plugged in / switched on
5. ran on short cycle

F-07 kept appearing still though each time I went through above steps the longer the cycle lasted. After about 12 attempts the machine got through the whole cycle and has been ok since.

With british gas for my leccy service so if it goes again i'll call them out to replace the part...
1.

Wishing-Moon
January 2011

Heater Relay Stuck.
This actually works...
Looking from the rear, there is a little cover about 3 inches tall by 1 wide.
DISCONNECT FROM MAINS
remove the plastic cover, you will see the Printed Circuit Board (PCB)
give this a tap, replace cover and just for good measure give the back a whack and hey presto!!

We were told a pcb would be £100 + software too at a further cost. £150 smackers for a tap!

bibmeister
October 2009

what does pcb mean?

william
June 2008

have a look at www.indesitservice.co.uk - it says " heater relay stuck,book an engineer "

kevin bradley
February 2008

F07 Heater relay stuck try tapping pcb 95% time kicks back in

engineer
January 2008