This will probably be a fault with the main circuit board or module. That code indicates that the induction coil is not communicating with control pcb - expensive parts to replace I'm sorry to say. If you are able to, get a multimeter out and test the resistance on the suspect coil and compare to the figure on one of the working ones, this will help you rule out if it simply a failed coil (ring)
Without specialist test equipment, it MAY be possible to swap a few parts around temporarily and try to run it breifly and carefully to see if it helps identify the faulty part. Only do this if it is practical and safe to do so.
Ultimately, if you are unable to safely do this, you'll need a rangemaster engineer out and be prepared to say goodbye to several hundred quid :-(
rangemaster 90?could you tell me if its the same steps on a rangemaster classic deluxe 90 as well please...Click here for the repair.
How can I get correct temp in oven?I have a rangemaster elan on which I recently changed the thermostat as advised on this forum as it was not reaching any temperature over 200c .it still appears to not be reaching 220c.. is there the possibility the switch turning the oven on to the selected temperature is faulty ?? Or something els...Click here for how to mend it.
Light bulb of Fan Oven keeps blowing?I have a rangemaster 110. The lightbulb of the fan oven keeps blowing at approx 200 C and trips the oven, might you know what the problem is?...Click here for the fix.
Hotplate full only?The large hotplate on my Rangemaster 110 only operates on full. Is it a fault in the hotplate or switch control?...Click here for how to mend it.
My rangemaster Toledo?both the ovens are not working on my cooker neither is the digital display. However everything else of fine do you know what the problem could be ?...Click here for the repair.
Any ideas what is the fault?Rangemaster dual fuel elan 110 main fan oven is only reaching 180c and light goes off..when trying to get 200c the light stays on constantly .. so not reaching proper temperature.....Click here for the fix.
i have a Rangemaster PROF90EIS with E2 fault ?my inductive hob is showing an E2 fault on the centre ring , can i fix it if so how...Click here for the fix.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.