Countax C350H backfires when i switch the key off?
can anyone help[p me resolve a problem with my Countax C350H lawn mower. When the engine has been running for 15 minutes after cutting grass ok I switch it off and when it stops running it backfires. Its a large bang. Anyone had this happen to them and if so what did you do to resolve it.
Hi, Mine does that too but only if you decrease the revs to idle speed before turning of the ignition. The correct procedure is to leave the engine at full operating speed when turning off the ignition key, that way you do not get the surprise backfire.
Can you bleed cluch fluid from countax c600h?My hydrolick fluid under seat is out of fluid can l top up and bleed air out l dont no were bleed nut is can you please help me thank you...Click here for the repair.
what size are the bearing on 36' deck on a countax?what size are the bearing on a countex deck its a 36' deck...Click here for the repair.
Type of transmission?Hi I currently own a Countax E36H model, approx 15yrs old. Can you tell me what type of hydrostatic transmission is fitted and can it be service ie oil change.
Cheers...Click here for the fix.
litres of oil needed in a countax c600h ride on lawnmower?My Countax lawn mower has a Briggs And Stratton 16 HP engine. How many litres of engine oil is need to change the oil...Click here for the fix.
Is it my Starter motor, or is it the solenoid?My Countax 600 has stood for over a year. Tried to start it but the solenoid just clicks. I bridged the solenoid terminals and the starter motor made a whirring noise but nothing else happened. Battery fully charged. Pressing the start button again just produces the click. It wont actuate the moto...Click here for how to mend it.
countax c300 gearbox oil?There is a small plastic container at rear of the tractor - looks like it is for gearbox oil. Is it? and if so what oil do you use (as mine looks like it needs some)...Click here for how to mend it.
Countax C600h cutter deck not engaging?Hi all. When I press the button to engage the cutter deck on my ride-on lawn mower, the grass cutter height light flashes 0. It does not seem to engage whatever I do. I have checked the fuses and am stuck. Any suggestions would be greatly appreciated. Many thanks...Click here for how to mend it.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.