Glow-worm economy 50 works with cover removed only.?
my Glow-worm 50 stopped firing up when heating was called for.the fan is fine and the sensor tubes were blown through and it started working fine.however when i replace the outside cover it stopped responding again.took it off and its fine...any suggestions
its a fault finding issue u will need to eliminate each issue to find the problem. by opening the cover u are allowing an increased amount of air into the chamber so u get a higher airflow causing the air pressure switch to operate.
it could be as follows.
1) check voltage at fan see if its getting 230v . if its below 200v its a fault control board not allowing the fan at full as it should.
2) faulty air pressure switch
3) blocked holes where the plastic tubes join on to give these areas a good clean as a reduced flow will affect it.
4) worn out fan not sucking enough air
Home heating systems?Further fault Glow-Worm F100 gas boiler.
When the boiler starts up the burner flame comes through the pilot light port. I thought that this must be because the fan was not working, i.e. not drawing the flame up through the water tubs. I checked the fan and it is running. I am now wondering if the f...Click here for the repair.
What can I do about a Glow-worm Flexicom 30cx fault code F11?I had a new boiler fitted in April this year. Last eve it stopped working, showing f 11. We have not been using the central heating, only hot water, for several months. In May it showed F25, but we bled the radiators and reset boiler and it has provided hot water ever since - but we have not used...Click here for the repair.
how can i fix my central heating. Glow-worm ultimate.?my boiler fires up and heats the rads . after about an hour the rads go cold, but the boiler keeps fireing
can anybody help....Click here for the fix.
Glow-worm micron 60ff boiler niosy ?when heatingMultifunctional control comes on hear a loud buzzing noise from the multi funtional control bottom right of boiler...Click here for the fix.
Intermittent boilet fails to fire on heating?I have a 5 year old Glow-worm CX35i controlled by Drayton Digistat SCR and analogue timer (on the panel). The boiler is failing to fire on heating demand by the timer and also the 'on/off' switch on the analogue timer. It fires fine on hot water demand, so I guess the igniter is fine and the probl...Click here for the fix.
water from taps is boiling hot?The boiler thermostat and the hot water tank thermostat are both working but this morning the water coming out of the taps is boiling hot. Any suggestions would be greatly appreciated. Glow-worm fulesaver F
Thank you...Click here for the fix.
radiators hot when water turned on.?when a hot water tap is turned on the radiators get hot. Glow-worm 24 ci...Click here for the fix.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.