How to mend ... Need New Housing

air in fuel ?

my transit 2.4 td van wont start there is air in fuel line when trying to prime the system i was told to push ... [Read more]

Belt replacement on Panasonic MC-E465K?

How does the cover come off to replace the belt on the Panasonic MC-E465K upright vacuum cleaner. I have remo... [Read more]

fitting TOOL BOX G10 ceiling light?

Has anyone fitted one of these.The electrics are no problem but I can't find how to fit the springs to the hou... [Read more]

how can i fix my hitachi 1st fix nailgun?

the fan in my 1st fix nailgun (hitachi nr 90gc2) which blows the gas around the chamber has simply fell out of... [Read more]

sagem axium htd501 wont turn on?

when turned on the red standby light comes on which then changes to a flashing yellow light it should then tur... [Read more]

fitting a new thermostat and housing on rover 75 k6 2.0 v6 year 2000?

apart from the housing and stat , what other parts will i need to complete the job

Mondeo 2 litre zetec petrol?

Hi, 2005 2l zetec petrol (estate) has a problem returning to tickover straight away, tickover is fine but when... [Read more]

how to change blade bearings on an L108?

trying to disassemble bearings from housing. any special format to follow

air filter removal on ford ka?

to replace my air filter on my ford ka, do i have to take the whole housing out of the car to do this, and if ... [Read more]

hyd. oil leak from middle of rear axle housing on b7100 hst kabota ?

my kabota B7100 HST suddenly started leaking hyd. oil from rear axle housing. I would like to know what is wro... [Read more]

section off bearing housing on 5030d dryer?

were can i get a drawing section of the bearing set up on a hoover tumble dryer model 5030d

jcb ht60600 replacement brushes?

Anyone have any idea where to get replacement carbon brushes for my jcb ht60600 hedge trimmer,or any compatabl... [Read more]

Skoda 2L TDI- Sump removal?

How do I remove the two inner sump bolts at the clutch housing end? All the others have been removed.

what's with the wiring?

My simpson mini max dryer built i think in the early 70`s has four electrical wires running to the metal housi... [Read more]

how can i fix my dyson dc14?

something arcing inside the motor housing, how do i remove motor from its housing to check there is no foreign... [Read more]

find a position to fix spring to clutch housing to tension belt?

replaced drive belt on mountfield m40 pd but can not find where to put the spring on clutch housing

Install chain break handle on McCullouch mac 100?

Chain break handle broke and I cannot figure out how to get the new handle to pivot around the back of the hou... [Read more]

How can I unjam pull cord on my craftsman weedwacker?

The pull cord on my Craftsman weedwacker is stuck/jammed -- can't pull it to start engine. How can I access th... [Read more]

leak on S/D f24E?

i have tried to cure a drip on a s/d f24e, the leak is on the flow sensor (grey plastic) where it enters the ... [Read more]

flymo strimmer model met 25?

how do i remove the spool holder housing from the rotor bar