How to mend ... Husqvarna

1

how to adjust carb?

husqvarna 388xp it sounds like its loading up when i run it wide open. then it made aloud pop like it back fir... [Read more]

1

How do I remove clutch from husqvarna 359 chainsaw?

I can no longer tighten chain to proper tension, I suspect the clutch may be worn. How do I remove the clutch ... [Read more]

1

husqvarna 41 oil pump adjustment?

how to decrease oil flow onto bar

5

my Husqvarna 350 chainsaw has spark, but won't fire. ?

The saw got really hot when I was operating it, and it died. I haven't been able to start it since then. It ha... [Read more]

how can I fix chain oil leak on a Husqvarna 365 ?

How do I replace o-rings for the chain oiler?

1

Husqvarna 350 Chainsaw (Reconnect Fuel Line?)?

Fuel spilling out when chainsaw on side. Found out priming bulb fuel line come off from one of two nipples on... [Read more]

Husqvarna chain saw 359 oil leak?

Oil leaks really bad from chain oiler It will leak out even when saw is not in use. I was able to get to the ... [Read more]

1

husqvarna 154se chainsaw wont fire?

my chainsaw has a good spark at the plug is getting fuel has had carb rebuilt and tested ok.compression of aro... [Read more]

1

Husqvarna 345 fuel tank is leaking?

Husqvarna 345 fuel tank is leaking. How do I seal it?

1

what are the cab tung setting for husqvarna chainsaws?

need to retune chainsaw,not sure what are correct carb settings.

3

husqvarna 345 chainsaw?

Were can I find a schematic ,for the fuel tank handle

1

i cant get my husqvarna 353 to start?

how can i get my husqvarna to start and stay running?

husqvarna 345e chainsaw?

i have a fuel leak from small hole (maybe breather hole) just below small filter and pipe on the outside of pe... [Read more]

1

how do I fix a fuel leak in my husqvarna 335xpt?

When I put mix in my fuel tank it leaks out breifly then stops. The leak seems to get worse as time progress... [Read more]

5

Husqvarna 254 Chainsaw hard starting?

There are times when trying to start my Husqvarna 254 chainsaw that it tends to lock up on rotation. It would... [Read more]

2

husqvarna 350 fuel problem?

just wondering if anyone can help me figure out a problem with my huskie 350. it starts and runs fine for abou... [Read more]

1

how do I install coil in 350 husqvarna chain saw?

Is there any settings I should be aware of when changing the coil

3

Husqvarna 041 bar not oiling when cutting?

I replaced the bar and chain with a new one.When I remove the bar and clean it,it oils fine.When I replace the... [Read more]

2

Gotta fix my husqvarna 365??

My husqvarna 365 chainsaw has a problem. It starts up great, good compression, but after 10 minutes of hard cu... [Read more]

1

husqvarna 254 removing drive?

I need to remove the drive sprockette from the saw due to it being sheared from the clutch drum. Is this a nor... [Read more]