How to mend Kenwood Mixer Chef

1

kenwood chef km200 mixer?

how do I remove the motor to fix the broken pulley spigot. I cannot find a way to separate the top half of mac... [Read more]

2

Are parts available?

Kenwood Chef mixer A702. Mixer quit. Where can I get parts and a parts list for this mixer? Also need repa... [Read more]

1

Kenwood Chef Mixer?

How/where can I dispose of my unwanted Kenwood Chef Mixer Model 701A? It belonged to my mother-in-law and I ha... [Read more]

1

im trying to fix a kenwood chef mixer a703c ,motor goes gearbox seems to wo?

i have the kenwood a703c the dog clutch doesnt seem to wind right down on top of the large plastic gear .

2

kenwood chef A701 kitchen mixer?

Motor runs OK speed control works OK, until the motor is put under increased load and it cannot cope, checked ... [Read more]

1

what to clean gearbox of mixer with?

have a Kenwood chef a901e mixer and I am replacing broken gears. I need to clean housing can I use petrol to d... [Read more]

1

how to remove supply cable from kenwood chef major?

how do I remove the supply cable from the kenwood chef major. where the cable enters the rear of the mixer the... [Read more]

2

Where can I get a Drive Pinion Assy for my A701A Kenwood Mixer?

Where can I get a new Drive Pinion Assy. for my Kenwood Chef mixer Model A701A.

1

how can I fix my kenwood chef pm900 mixer?

Mixer only runs if you hold in green start button, stops if you let go. Fitted new switch panel still same pro... [Read more]

2

How to adjust the speed controller on Kenwood Chef A901B mixer?

Can some one please advise me on adjusting the speed controller on KENWOOD CHEF A901B Mixer. I tried to set it... [Read more]

1

What is the wattage of the 220 ohms 5% resistor on a kenwood chef 901 mixer?

What is the wattage of the 220 ohms 5% resistor on a kenwood chef 901 mixer

3

is kenwood chef model A702 parts still available?

I need the bread mixer accessory

2

How can I fix my Kenwood Chef Mixer?

The motor of my kenwood Chef A701A (30 years old!) mixer no longer drives the planetary action of the beater. ... [Read more]

1

I need rubber feet for a Kenwood Stand Mixer KM410?

Chef Classic KM410

1

Kenwood Chef Circa 1960 Drive Dog Off gearbox shaft?

Is the A701 model circa 1960 ? if so where can I find a new Drive Dog that screws on top of the gear box shaft... [Read more]

1

Kenwood Chef model 701A?

With K beater fitted, mixer was on low speed and suddenly there was a screeching noise. beater then made a cl... [Read more]

2

faulty motor Kenwood chef major A 717?

we have smoke coming from the mixer and the motor speed controller doesn't work.Any suggestions please and tha... [Read more]

1

Kenwood Chef Mixer very noisy?

My mixer makes intolerable noise while beating and does not beat well even though its on the highest speed.

3

Kenwood CHef Food Mixer Model A901 Speed control?

Kenwood chef speed control model A901 with mechanical govenor. resistor burnt out olso 0,o47mf capasitor bu... [Read more]

3

Kenwood Chef A 901 bang and smoke?

I use my Kenwood Chef A 901 Serial # 0840909 for mixing boilies which is quite a heavy job I presume It is 50... [Read more]