Leak in hotpoint first edition 800, WM51?

hot point first edition motor seized wm51 any recon motors out there ta

shane
March 2011

Hi,

On a similar model Ultima 1200 which has been standing the joint between the input hot water pressure sensor and the nylon inlet housing was lose. A few wraps of narrow repair tape has sorted that but now asking to check output hose.

On my 800 there are two splits in the seal round the door is that a DIY job How much is a seal and how much should I pay for it to be done? Does the seal include the green steel ring which is next to the drum as that seems a bit rusty at the bottom.

Cheers. Andrew.

Andrew
August 2009

You may have sorted this already, but the most likely problem is the seal between the drum and the door. It peels off fairly easily once you've opened the door - there is a ring round the edge held by the little grey clip to the top left of the opening. you can normally se holes in it withouth takin it off though. just stretch it and feel around. If that doesn't sort the problem, it could be the tubing by the trap at the bottom or feeding from the drawer to the drum. Its most likely one of those.

Jamie
September 2007