Delonghi DFS 901ss?

I have just bought one of these cookers on ebay and on getting it home, found that the door did not shut. After some investigation I have fixed ours without having to buy new parts. What I found was that the hinge receptor (where the hinge does into on the cooker) was bent out at the top causing the whole door and hinge mechanism to come to the top of it's cycle before the door is fully shut. This could have been caused by the door being lent on or slammed open, ie being opened too far. THE SOLUTION: remove the door by opening and pulling the latches over the sprung part and pulling the door up and out. Have a look at the area around the two slots either side, take a screwdriver and place in the lower slot and push upwards until the slots are in line. Pop the door back on and it will be like new - no more hot knobs!!

Richard
June 2009

we did the same and then bought a new face plate

Does anyone know how to adjust the door hinges - our door is not closing completely and the knobs get very hot as a result

Eric
December 2008

I did the same all the controls came off when cleaning too!!

Chris
August 2007

full panel req...expensive..

greg ...
www.atsscotland.co.uk

greg
July 2007