Kenmore series 70 will not pump after wash or rinse cycle?
Same problem as above will fill and agitate then not pump. It will pump on spin cycle if I advance the timer. I bought a book says nothing about this problem
although I required more than removing the washer from the lid trigger for the sensor, the lid sensor was the problem with the washing maching and I appreciate the solution to this problem. Thanks for your help.
Ron
August 2010
tom, i had the same problem with our washing machine.
I AM NOT AN APPLIANCE REPAIRMAN ,BUT
WE FOUND THAT THE SWITCH/LEVER THAT IS DEPRESSED BY THE PIN/POST ON THE UNDERSIDE OF THE LID THAT TELLS THE MACHINE THAT THE LID IS CLOSED WASN'T DEPRESSING FAR ENOUGH TO ACTIVATE THE SWITCH.
If I PUSHED DOWN ON THE LID ABOVE THE POST/PIN THAT ACTIVATES THE SWITCH IT WOULD SPIN/DRAIN.
I TOOK THE THICK RUBBER WASHER OFF THE POST ON THE LID AND TRIMMED ABOUT 1/16 OF AN INCH OFF IT. THIS ALLOWED THE POST TO ACTIVATETHE SWITCH. I DID THIS YESTERDAY
AND IT HAS WORKED FINE SINCE. HOPE THIS HELPS
JOHN FROM MJ
July 2007
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix washing machines.