aeg 88840 update, error code c3?

Any idea on where the water can come from? I followed the tip, dryed up the water on the bottom plate, removed a lot of dust in the front shutter rubber cuff, tested running 2 short programs, put the machine back again, run a full program and now I have got C3 again. So. Where can the water come from?

tb
September 2009

how do you give the system a full reset or witch buttons do i have to push

marcel
August 2008

I just fixed this problem on my own AEG. seems if a little bit of water gets in the bottom of the machine it trips the overflow sensor and the machine turns on the pump so you don't flood your laundry. As the other person has said, open up your machine (unscrew at the back) and dry out the bottom, including under the trip switch (under the drum) should reset and work fine after that. See if there is any obvious cause that might be causing the leak, I just had to change a washer and tighten a connection...

Steve
July 2007

have you got water in base and float swich activated?.if so find where leak is from and dry base out

ck
June 2007