Tricity Bendix TM310W Tank full light will not reset?

Under the water bottle is a drain hole,when the bottle overflows water runs down this hole through a pipe to a reservoir behind the condensor unit, there is a float in this reservoir that rises and clicks a switch that activates the full tank light and stops the machine working,
removing the stopper at the rear and emptying the reservior should do the trick,If the float does not go back down due to dirt in the machine the left hand side panel can be removed by taking off the top then the retaining screws,one inside at the top the rest in the back panel,remove the one screw holding the float switch unit and clean the black float.(Make sure it's not plugged in)

Bob
January 2008

simply turn the program dial one click at a time to the start of a program cycle then the light should come on. press the start button and the green light will come on but nothing else happens, DO NOT DO ANYTHING ELSE, just leave the machine as it is and about 2 minutes later the lights will reset itself and the machine will start working.

john moore
October 2007

should not have full drum only fills to just on glass door ;check water pipes arnt kinked and that both hot and cold water does flow into washer

dave
May 2007