I can start my McCulloch Eager Beaver 2014 chainsaw, but when I pull the throttle open, it won't go to high speed. I replaced the fuel lines, and the screen in the exhaust is not plugged.
Need to adjust the high/low settings near below choke lever. using a #2 screwdriver run screws in, ( should be about 1.5 turns reference this) turn each screw out a fuzz futher than that 1.5 turns . Start saw following the instructions located under trigger . You may find futher adjustment may be required . Be careful
na
May 2009
I don't know. I have exactly the same problem. When I apply the trigger the engne begins to slow down.
Its not the gas, spark plug or air cleaner.
John Konrath
April 2007
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
