Recent: Home max fs506x?

Mend > DVD Players

Mend Bush DVR3003 Standby Mode Help

BUSH DVR3003 stuck in standby mode?

My Bush DVR3003 is stuck in standby mode. Can anyone help me to get it operating properly again?

Bob
February 2007
THANK'S HENRY
same problem on my GVD 8618 UX

i replaced 3 caps c126 -c127 -and c158 works well now

Dominique from Orléans(France)

DOM 45
June 2011
I have the same problem but the 2200 mF, 16v are ok the volts on 12v go up and down same with the 5v and 3.5v, the blue standby led flashes on and off will not turn on the optical socket goes on and off to. its like a flaser unit all power does it, but its not a Bush its Goodmans GDVD306R, Has any one got a clue? or were you can get a new board from thanks.

Russ
January 2009
I had the same problem with the dvd stuck in standby mode with the blue light on and discovered that the 2 capacitors were slightly bulging at the top end, 2200mf 16v and 470mf 16v.I am going to try replace them, i am told you need to make sure that the capacitors are the right way round, ie positive and negative connected the right way.Its worth a try as the cost is £1.10 for the 2 capacitors.

Henry
October 2008
i replaced 3 caps c126 -c127 -and c158 works well now

pete
September 2008
There are 2 electrolytic capacitors close to the chunky heat sink of the STPS745FP schottky diode - centre left of the 12PW14-4C power supply board viewed from the front. One is 2200 mF, 16v and the other is 470mF, 16v. These are very close to the heat sink which runs quite hot. Heat shortens the life of electrolytic capacitors dramatically. You may find that the ends of both capacitors are bulgeing and the vent may have blown. In my case the unit appeared to be stuck in standby since the blue front panel led was lit. However the unit would no longer feed through a signal from AV2 input scart to the AV1 output scart which it will do in normal standby. Voltage checks inside the unit found that while the 12volt line was normal, both the 5volt and 3.3volt lines were way down. Replacement of the two electrolytics restored normal operation. Look for good quality replacements - preferably rated for 105C and with a high ripple current rating and recommended for SMPS power supplies.

Dermot
May 2008
It seems to be a common fault with this model. I have had the same problem and powering off and on was the only way to get it to work. However, it is now stuck permanently in standby mode (Blue light on). No evidence of any burnt-out components though. Looks like I'll have to ditch it.

Brian
April 2007
Mine did the same thing, switch off the mains for 30 secs then turn back on and it was fine, however a couple of months later the PSU board blew, frying the fuse, blowing 1 capacitor and cracking a chip..........now I have to find one from somewhere to fix it!

Phoenix
February 2007

Related Questions ...

Mend plasma tv no power tv repair
1

how can fix goodmans 42 gtv42p4 plasma tv?

Have problem it seems my plasma tv is not showing any red light hence on standby mode i have switched it on an... [Read more]
Mend freeview off tv
1

Techwood freeview STB dv925b switches off TV. Why?

Had my set top box for about 18 months now. It started out brilliantly but now seems to suddenly switch off th... [Read more]
Mend boiler central heating fault
1

Domina 80E CH fault?

I can get hot water easily and constantly but the central heating doesnt work properly. The CH comes on when i... [Read more]
Mend stuck mode box
37

ONN TV stuck on stand by mode?

Hi I have a 32" ONN TV that worked fine with my sky box and just got stuck on standby and will not turn on. I ... [Read more]
Mend Trinitron Sony Blinking
2

How can I fix my Sony Trinitron tv model #KV-32HS510?

My Sony tv is a 2003 model and has gone into a standby mode and will not power up. It flashes a red light and ... [Read more]
Mend correct problem time
1

My PC date/time will not display the correct information?

Hi Folks now this is my problem the Clock on my PC will not keep the correct time I Have changed the battery I... [Read more]
Mend help stuck course
1

philips tv help?

same old my tv is stuck on standby mode any answers outhere(sensible of course) for this great tv. i... [Read more]
Mend monitor standby mode screen
4

computer monitor goin on standby mode?

can any1 help me with a problem tht is really doin my head in now !!! i av a desktop computer and the montior ... [Read more]
Mend turning standby mode
1

how do i fix my teac AG-5D home theater reciever?

keeps tripping off when turning on in standby mode can anyone help.already had it to local TV repair shop t... [Read more]
Mend buttons turn model
1

tv ?

tv in standby mode-remote lost, buttons on tv do nothing so i can't even turn it on--sony trinitron model KV29... [Read more]
Mend Philips red light remote
1

philips matchline tv help?

tried turning on the tv but stays in standby mode (red) using the remote pressed a number but the red light ... [Read more]
Mend bought years find
1

Tv turning itself off?

Hi This TV was bought about 4 years ago and I cannot find it online to trouble shoot so wondered if you can... [Read more]
Mend panasonic picture standby
1

Pansonic TX-28DK1L switches to Stanby automicatically ?

When I switch on TV, it switches to standby - can't view the picture. 2 weeks prior to this, it was happening ... [Read more]
Mend box stuck standby help
3

Thomson Sky+ box is stuck in standby mode?

My Thomson Sky+ box is stuck in the standby mode, can you help me fix it?
Mend box standby reset
4

skyplus box stuck?

pace skyplus box stuck in standby mode.have tried to reset but does not seem to work can anyone help.

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend DVD Players ...