leaking dishwasher at the bottom off the door?

check also the white nylon 'n' shape bushes that sit in the door hinges BSH part number 165296. The door pivots on small rods on the case of the appliance and if you pull the dishwasher out using the door! you can break these bits which means the door doesn't sit correctly and thus leaves a gap down the edge as it closes.

not another motor seal job !!
April 2014

Am impressed you have changed the door seal, did you ensure the grey plastic end pieces were held BETWEEN the hinge and the door skin. Also the seal fully located on the floor pan. Changing this seal always solves the problem if it was the seal at fault, old one goes wrinkly and like jelly. Other causes of leaks at hinges ;- door not closing tight enough, machine overfilling with water, low water inlet pressure. Cheers

Kenjo
December 2013

check the spray arm holes aren't blocked as this can make water spray under seal.if this is OK tilt the dishwasher slightly bacwards to encourage water to go to the back rather than up under the front door seal

CK
December 2013