I have put in a new motor control module and re set the water height etc, it washed 2 loads and then stopped at the rinse cycle some error lights came up but then wouldnt power back up at all before i could write which error code it was, the fan beneath spins freely..any ideas..? cheers..
Check the drain pump. It is part of the power supply circuit to the board. If pump is open circuit it will appear dead. Take pump out and check copper winding for discolouration & signs of over heating. Put a multimeter across the two terminals and it should rear approx. 33.5 ohms. Any less than 32 ohms replace it. Do not try to run it if pump is at all bad. It will blow the control module. It may have already. If with a new pump it still won't power up then the module is damaged. All these things should be checked before powering up the new module.
Linoln Appliance NZ
May 2013
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix washing machines.