Recent: Home max fs506x?

Mend > Fax Machines

Mend Brother 820MC Hold Time Setting

Brother intellifax 820MC wont hold date and time setting?

I have a brother intellifax 820MC that will not hold the date and time. I am assuming that the small battery has gone dead, The problem is, that I cannot find the location of the battery so that I can change it. Suggestion of where to look will be appreciated.

George M
November 2006
The battery is located beneath the phone receiver. To access it, tilt open both the keypad and the paper roll storage cover. There is only one philips screw located at the left end of the paper roll. Remove it, and the cover, along with the phone receiver, lifts off. The four-pack, wrapped battery is along the end closest to you. It easily un-plugs and is removed. Since it is no longer possible to find these batteries on Planet Earth your best bet is to take your make and model number, as well as the spent battery, to your local Batteries Plus dealer. They will not be able to find the make and model in their computer but they always like to look anyway. Go on a day when they are not busy and the manager is working behind the counter. If he is in a good mood he can actually make a battery for you. Good Luck.

Duane Alberts
May 2008

Automatic Answer

We may have found other answers which could help you.

Click here for Hold Time Setting

Related Questions ...

Mend baxi gas flame

baxi brazlia wall mounted gas room heater flame keeps blowing out?

My wall mounted baxi brazilia room heater is causing a problem, the flame which I can see through the small in... [Read more]
Mend hold times time second

Why does my Siemens RDJ10 not hold the setting times for on and off?

I enter first time ON at A1 than time OFF at A2 by the time I get to A2 which is the second time ON A1 and A2... [Read more]
Mend How to mend it?
1

My ku990 screen is extremely bright all the time , it won`t hold it`s setti?

My KU990 screen is extremely bright , adjustment is impossible as it is not holding it`s new brightness settin... [Read more]
Mend wont its settings

Mircomark 6 zone alarm won't hold its settings?

We have a micromark wired 6 zone easyfit intruder alarm which sets correctly and holds the setting for a short... [Read more]
Mend setting time manually

SETTING CLOCK?

My ZV450MW8A clock will not hold the correct time. I set it manually and at 12am/12pm it jumps ahead about 5 ... [Read more]
Mend boiler heating fault
1

My Vokera 36he fine at heating but hot water cold?

Exellent for heating but when asked for DHW (domestic hot water) it cut the boiler out displaying fault 79 (te... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Fax Machines ...