I tried to change my user code,I pressed PROG,entered my current code, but I did not read the intructions right and didn't key the number '8' I entered the new code 5689, the alarm went off, I just kept entering numbers and eventually the alarm stopped. I reset it, then keyed in 5689 but again the alarm went off. I tried entering my old code but the alarm still went off.Basically I have no idea what i have done, i think i must have chnaged the code but i don't know what to. When I key in the first 3 numbers of my origianl code the alarm starts bleeping, so could it be those 3 numbers plus one other that I don't know yet. Would the alarm code have changed even when I didn't enter the '8'? Please help.
Sounds like an old Optima.
press RESET 3 times and try your code again, the old one.
But if this works you have probably stuffed up the programming so beware and TEST everything first.
Full sets and part sets and that they do as required and the bells ring outside.
Alarm
April 2012
Duh?
Q. What panel is it?
This is the minimum basic information to give when asking a question, no one can help without it!
Q. How is anyone supposed to be able to help you?
Bye
acorn
April 2012
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
