Visteon 6000NE have code need more?

code for M349701

ys4f-19c815-aa
May 2022

hi i need code for m308588

ASHWIN
September 2014

ok so have you checked all the plugs are pushed in at the back and the aerial?
when you check the plugs try the radio then. to see if it an aerial problem hold a screw on the aerial jack(hold) to see if it will tune.

hay88
July 2011

When I took the CD/Radio back out and connected it the display flashed "1746". After I entered that code I got the radio display. It will seek but it never stops. It will respond to the pre-set buttons by stopping at a particular frequency. However, there is no sound. I tried using a piece of wire as a temporary aerial but that didn't work either. Please help.

BTG
July 2011

Btg
when you turn the radio on whats is on the display please
??

hay88
July 2011

The serial number is M004812. If I leave power off overnight then hold down "MENU" and scroll down I find "CODE". If I enter "1746" I return to the radio that doesn't work. If I hold down "MENU" again and scroll down I find "VID". If I enter "1746" I get a blank screen except for a flashing cursor on the left hand side. I can enter characters using the volume control. However, the Vehicle I.D. from the paperwork doesn't work. Is there any way to reset it? Many thanks.

BTG
July 2011

bt
where did you get the serial off the radio or out of a book? if its from a book remove it and get the serial off the back of the radio.
if it is off of the radio try code 4580< that for visteon
thats the code for that serial 1746
Code Entry as Follows:

Switch Radio On - Display Shows
CODE with " - - - - " flashing
Press preset " 1 " repeatedly for 1st Digit
Press preset " 2 " repeatedly for 2nd Digit
Press preset " 3 " repeatedly for 3rd Digit
Press preset " 4 " repeatedly for 4th Digit
If the correct code number is now shown
Press preset " 5 " to Enter

hay88
July 2011

Yes. I have the booklet for the CD/Radio. Unfortunately, the previous owner didn't record anything in it.
If I enter a different number it starts counting - I gather you have 10 attempts before something worse happens.
Thanks for asking.

BTG
July 2011

Did you press button 5 after the code was displayed on the LCD display?

nigel
July 2011