water wont stop filling ?

your limit switch isn't working, so the machine doesn't know when to turn off, also there is a tube on some models that become full and get an air gap that gives the machine bad info There is a pressure switch hose that is attached to an air dome. This switch tells the washer that there is water in the tub and allows the agitator to start.
- Remove the control panel and you will notice a small hose. See if it popped off of the air dome. If it did, secure it with a zip tie.
If water flow continues, but drains out immediately, then raise the drain hose above the highest water level line of the tub. Do not seal the drain hose to the discharge pipe. This could cause a siphoning action.

canwoodjc
July 2011