Recent: Safely remove screen protector from a Macbook Air?

Mend > Home Alarm Systems

Mend Scantronic 9752 External Sounder

My external sounder omits a beep almost every 30 secs to 1 minute?

my external sounder omits a beep every 30secs to 1 minute, can someone tell me why? I have a scantronic 9752.

Deeko
April 2011
to put it in a nutshell,alarm systems are like central heating,you only want to pay for it once,so you dont fit cheap trash

gts
May 2011
i knew alarm guy would clarify,we buy in new bell boxes and put then through a bench test,hot,cold,short circuit,voltage over load,under load,we freeze them,soak them,only if they pass our tests do we use them,it cost money,but,our test eliminates the dross,so in the long run,we save money,we bench test all our panels,pirs,door contacts,panic buttons,vibe detects,even our batteries,that is why we have few call outs to our systems,most are user faults,so,if you replace your sounder,buy a descent one,

gts
May 2011
as was mine :-)

gts
May 2011
The sounder GTS mentions does this in low temps.
My guess is a smoke alarm.

If it turns out to be the sounder just relace it.

Alarm
May 2011
just replace the bell box,simple fix,i have heard from acorn and alarm guy on this site about some bit of rubbish that goes faulty and you have to solder or cut some thing off,best to to replace it,if your certain it is the bell box,and not a smoke detector :-)

gts
April 2011
difficult to answer 100% but could be a faulty external sounder box

A1
April 2011

Related Questions ...

Mend alarm guys bit
4

alarm sound travel?

hi there guys, bit of a weird question but i have a scantronic 9600 with a texecom odyssey 3, and sometimes i ... [Read more]
Mend security system failure
3

Scantronic 9600?

Hello all,hope you can help me with my 9600?, The old girl has been going strong all these years until last n... [Read more]
Mend security system keypad
11

Scantronic 9800 problem - how can I get it to work?

A Scantronic 9800 was fitted to my house many years ago and the very elderly previous owner lost the codes and... [Read more]
Mend bell hello advice
4

do i need to enter engineers code to dis-connect external bell box and repl?

hello need some advice, have tested bell-box which has a supply present from alarm panel of 12v d.c,the o/s so... [Read more]
Mend alarm sounder battery
6

scantronic 9448+ external sounder not working?

scantronic 9448+ outside bell does not sound when it should, but the sounder in the house does,has the outside... [Read more]
Mend scantronic 9800 bell box
1

Scantronic 9800 External bell box fault?

My external sounder went of in the bad weather - turns out some tracks on the circuit board had corroded - any... [Read more]
Mend scantronic sounder battery
2

scantronic 9200 external sounder battery?

I want to know what battery is fitted in the external sounder of the Scantronic 9200, It needs replacing and w... [Read more]
Mend alarm keypad home security
1

scantronic 9427 keypad sounder?

Hi all, I have install a 9427 keypad to a 9448+panel every thing seen's working fine ,But when the alarm go's... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Home Alarm Systems ...

Related Categories

Mend Car Alarm Systems
Car Alarm Systems