replaced thermal fuse couple of times in ghd mark 4 (pink) they then switch on but after 30 sconds, led is on still but not flashing, after 1min thermal fuse blows
behind the opposite plate to the thermal fuse is the temperature NTC sensor, suspect this faulty,check solder connections and still attached to heater or it may be just the heater on that side is dodgy, does it heat if not then straighteners overheat on thermal fuse side believe heater should be about 70 ohms not sure about ntc but should change as held in hand(believe may be 100 kilo ohms
bob
November 2010
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix hair straighteners.