hoe to get steam from my russell hobbs steam glide generator iron?

I got difrend problem the red water problem light dosen't turn on.when i press the triger nothing happen ...i try the pump without the hole electronic and pump is allright. Why the red water problem light dosen't turn on ?

David
September 2010

Rank: Apprentice
Rating: 100%, 2 votes
I had a problem and tracked it down to the pump. If you take the iron apart, the pump sits towards the front of the iron and has 3 tubes connected to it. Remove the srew-down bracket and free the pump from the plastic clasps on the base. Disconnect tubes and wires (remembering where they go.

Remove the circular securing spring from the front of the pump and drop the metal barrel from the housing. Unscrew the rear plastic assembly and set aside. there is a joint inside where the plastic assembly was - this is has an o-ring and is simply a pull-apart. It deos not need screwing. Pull the metal barrel apart, taking care to note the sequence for reassembly. Inside the barel is a larger rubber washer. Pull on the metal tube that goes through the centre of the washer using a pair of pliers - it will come free.

You will then see the problem - the spring inside the metal barrel will have broken. Take care, because at the other end of the spring is a small plastic washer that must be retained. Find a pen that has a short spring inside and use this as a replacement. If necessary, you can trim the spring to make it the right lenght. Ensure you have removed all broken pieces of spring, and reassemble. Try it out before finally attaching the pump inside the iron. It took me 2-3 attempts to get the spring tension right. If you can find a 'PENAC RB-085B BA1002' pen, the spring is perfect.

Once you have got it right, reassemble.

I have to replace the spring approx every 6 months as the replacement is obviously not meant for the job and wears or rusts or breaks. However, I am getting extended use from my otherwise broken iron.

Take care - things inside get HOT!!

Hope this helps.

(Found this possible solution on another web-search)

Thanks Scott

Was this helpful?YesNo
Solution #3posted on Oct 05, 2009

746rog

Rank: Apprentice
Rating: 100%, 1 votes
I followed Scot8oy's advice and removed the pump. The spring wasnt broken so I put it back together and it now works. Maybe the pump was just sticking but its done the trick so thank you!
I would however reitterate Scots last point. The insides of the iron get very very hot. As Terry Wogan would say " See the blisters "


Rating: 87%, 307 votes
fill with limeaway let it sit for about 2 hours.. empty.. fill with water

William
August 2010

My Steam Glide also just stopped producing steam - still looking for a solution.

William
August 2010

i have the same problem and doesnt work,
tried the filter and still not working. let me know. Manisha

manisha
July 2010

Try changing the filter

Phill
July 2010