Bosch Washer with E2 error - how to reset it?

Thank you very much worked a treat although it didn't flash just reset the display and needed to run through the 15 miniute ez program. Which I let it do!!!
Sandy
April 2024

Sandy
April 2024

This worked for me too - thanks Linda !

Andrew
August 2017

Hi All
Worked a charm fir me
Thanks Linda. Saved me the cost of a repairer.
Michael

Michael
April 2017

Thanks Linda...couldn't fixed it without you.

Carmen
February 2017

Worked like a charm thank you so much :)

Michelle
June 2015

hi my bosch front loader had a code e2 so i done a master reset now the water goes in but the tub does not spin a round when i first switched it on it did for a second thanks bob

robert
March 2015

Linda's reset method worked perfectly for me.

Rod
February 2015

Thank you. Worked perfectly.

Melinda
October 2014

Reset method described in this thread worked like a charm. Thanks.

Scott
January 2011

Thanks a million it worked straight away!!

Brooke
October 2010

I found this by ssnja57....
The e2 error is a generic error that the machine shows if it's been overloaded or if the load becomes unbalanced during a wash cycle.

To fix you must do a master reset of the washing machine.

1. Close the door and make sure the dial is pointing to the "OFF" function
2. Hold the Start/Pause button and turn the dial anti clockwise (to the left) to the "express 15 min" program at the same time.
3. Hold the Start/Pause button for a minute (the e2 message is meant to start flashing after a minute of holding the button down however with my washing machine this didn't happen) (and neither with mine)
4. Release the button and turn the dial back to the "Off" function.
5. Select any program and the message should not be appearing.
This worked for me ... Linda

Linda via ssnja57
May 2010