changed front master cylinder on a speedfight tried to bleed but master cylinder is not drawing fluid in.or pedal getting any harder
the cylinder was changed because the first one brake pedal was really soft and coming in about halfway (master res was full) it passed a MOT like this
correct method of bleeding please, have been told different methods none work wonder if the replacement any better can you get replacement seal kits
i would suggest this,fill the resevoir up and then clamp the hose just past the brake hose banjo union at the top,clamp it with a pair of thing mile grips but put some cloth on it so it doesnt damage the hose then pull the lever and see if you have a good brake then if you do then take the mole grips off and loosen them just a littl bit so you can just push the fluid pat it if you pull the lever hard then undo the bleed nipple and keep pumping until all the air is out mkae sure you dont run the resevoir out of fluid.if it doesnt have a good brake after clamping it try to tickle the lever a bit and then watch for bubbles coming up through the fluid in the resevior.after a while it should be ok to bleed as previously said.
adam bike doctor
March 2010
when you bleed it. open bleed nipple a tiny bit.open to much and you cant bleed it .
rayb
March 2010
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix motorcycles.